Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in ShopNotes magazine.

July 2009
Issue 106
- Table Saw Project Center
- Page 28: Figure 2 callout
- The callout in Figure 2 shows 5/16"-18 x 2" hex bolts, nuts, and washers but they are too big. The callout should say 1/4"-20 x 2" bolts with matching nuts and washers. Note the materials and hardware list is also affected by this change.
- Page 32: Materials and Hardware
- All the 5/16” hardware items should be changed as follows: (26) 1/4"-20 x 2” Hex-Head Bolts ; (26) 1/4"-20 Hex Nuts ; (26) 1/4" Washers.
- Page 51: Source for Leg Levelers
- The source for the Leg Levelers was omitted from the original issue. They came from Rockler, part number 81239.
- Page 28: Figure 2a
- The 1 7/8" center-to-center distance between the slots in the Kreg Klamp Trak is incorrect. The correct dimension is 1 1/2".
- 7 Must-Have Tapes
- Page 11: References to Shrink Tape
- The tape described in item 4 should be called "Stretch Tape", not "Shrink Tape". It is correctly referenced on the Sources page.