Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in ShopNotes magazine.

November 1998
Issue 42
- Edge Clamps
- Page 8: Figure 6.
- Note written in master copy: " 47 degrees correct. 55 degrees will work." Note on page 28 refers back to this.
- Shop Solutions
- Page 28: Instructions
- Both text and illustration indicate that the miter guage should be set to 55 degrees, but it should be 47 degrees.
- Page 28: Illustration
- Both text and illustration indicate that the miter guage should be set to 55 degrees, but it should be 47 degrees.