Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in ShopNotes magazine.

November 2003
Issue 72
- Drill Press Belt Sander
- Page 10: Figure 6 detail a
- Diameter of hole on the right edge printed as 3/8" but it should be 1/8".
- Page 13: Materials
- The Short Supports are labeled as being piece R, but it should be T. Drawing is correct.
- Fold-Down Workstation
- Page 30: Figure 8 detail c
- Drawing indicates that the side extends 1/2" below the bottom but it should be 3/4".