ShopNotes Magazine

Updates & Revisions

Here you will find important updates and revisions to the articles and plans published in ShopNotes magazine.


Woodsmith Issue 78 cover image

November 2004
Issue 78

5 Plywood Shop Projects
Page 29: Figure 2
The large plywood piece all the fence stuff is being attached to is actually the "TOP" not the "STOP."
Page 31: Illustration of adjustable, stackable assembly boxes
The dimensions of the 4 boxes in the illustration on the right edge are incorrect. From top to bottom: 1. Height printed as 63" but should be 47". 2. Height printed as 47" but should be 34". 3. Height printed as 22" but should be 23 1/2". 4. Height printed as 15 1/2" but should be 17".
Page 25: Figure 2
Two incorrect measurements. 1. Drawer Front measurement printed as 5 1/4" x 22 3/4" but should be 5 1/4" x 22 1/4". 2. Measurement of Drawer Bottom printed as 18 1/4" x 21 3/8" - 1/4" Hdbd. But should be 18 1/4" x 21 1/4" - 1/4" Hdbd.
Router Miter Trimmer
Page 19: Figure 3
The measurements on the left end of piece E - Adjustment Block should be 3/16" and 5/16" not 5/16" and 1 1/2" as originally printed.
Page 19: Figure 1
The measurement of piece B - Backstop should be 7/8" x 2" - 42", not 1" x 2" - 42" as originally printed.
Jointer Tune-Up
Page 16: Text in last paragraph
The last lines were cut off in the original printing. The sentence should read: "With the knife in place and resting on the leveling screws, snug up the gib bolts a bit (not tight). I like to start with the center gib bolts and work my way out to each end."