Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in ShopNotes magazine.

November 2007
Issue 96
- Custom Chisel Case
- Page 31: Figure 1a
- The drawing gives the impression that screws go through the Back Panel (E) and the Wall Cleat (G) and Lower Cleat before engaging the wall studs. The lower screws do go through both the back and cleat since this part of the case is hidden behind the door. However, the screws at the top are only used for attaching the wall cleat to the wall.
- Multi-Purpose Disk Sander
- Page 20: Figure 1, Top View
- The Top View illustration shows the motor runner positioned 2 15/16" from the front edge. This dimension should be 3 11/16".